THIN RING GM350 STD
Set of segments for a standard size piston 1.5 x 1.5 x 3mm.
Compatibilité inconnue ou non renseignée, Contact us
Voir les produits compatibles
Produit compatible
Set of segments for a standard size piston 1.5 x 1.5 x 3mm.
Kit of 8 new V8 GM small GM engine blocks GM305 or GM350.
Mounting with screwdriver type ARP 3/8.
Repackaged V8 small engine type block 5 litres or 5.7 litres.
Set of pads for a standard gauge of diameter 53.34mm and width 21.3mm.
Attention for the recent GM181 4-cylinder engines with a width of 19mm, please refer to the reference 23-804982.
Cushion set for a shear of repair 0.25mm , width 21.3mm.
Set of pads for a side-by-sided support 0.50mm , width 21.3mm.
Set of pads for a double sheath repair 0.75mm, width 21.3mm.
Hydraulic pushers with a roll to follow the lobes of the camshaft.
Unlike RHT817 chicks which are flat.
Cap diameter 1/4 NPT - 13.15mm with male head hexagonal 6 pans.
Rear joint for spi joint of vilebrequin 1 pcs.
Pièce non en stock.
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
Housing for rear vilebrequin spi joint on GM 4 - 6 and 8 cylinders.
Pièce non en stock.
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
Complete set of V8 base GM engine bearing pads in standard size.
Complete set of bearing pads for GM base V8 engine 0.10.
Complete set of bearing pads for GM base V8 engine 0.20.
Complete set of bearing pads for GM base V8 engine 0.30.
Plastic dispenser for V8 motor with hole for the vilebrequin position sensor.
Carter including the spi joint and the barrel joint for winding.
Vilebrequin position sensor mounted on the V6 and V8 small block plastic distribution board.
As well as on the front face of the 8.2L and 7.4L engine distribution system.
Front Damper for mounting at end of vilebrequin with a diameter of 203mm.
Brass pump joint for V6 and V8 GM base.
Joint sold individually.
Brush pump for water circulation in the engine block.
Planned assembly for V6 - V8 motor with a sheet metal or plastic distribution cardr.
Fixed by 4 screws above the distribution cardr.
TE91112 winding joints included.
For V6 Vortec engines with an aluminium distribution system only you refer to the W898N reference.