CRUSADER OIL DIPSTICK TUBE
Oil gauge tube to map oil with a peel on the side of the crankcase.
All parts for the constitution of an oil gauge kit are:
- 98287: transmitter
- R041072 : gauge tube
- BRA400-3838: oil connection
3/8 gauge tube thread.

Oil gauge tube to map oil with a peel on the side of the crankcase.
All parts for the constitution of an oil gauge kit are:
- 98287: transmitter
- R041072 : gauge tube
- BRA400-3838: oil connection
3/8 gauge tube thread.
Alarm probe present on the lower thermostat card of the Crusader engines without mounting with instruments VDO.
Thermostat valve for raw engine
Higher thermostat housing for Crusader motor.
RH reverse engine starter with a fastening on the top of the coupling bell by 2 screws.
Mounting to the opposite of the engine block.
Asshole screw kit for a complete V6 4.3 liters and V8 5 - 5.7 - 6.2 liters.
Common Kit V6 - V8 deletion kit V6.
Front Damper for mounting at end of vilebrequin with a diameter of 203mm.
Démarreur à réduction pour moteur en rotation inverse RH disposant d'une fixation sur le haut de la cloche d'accouplement par 2 vis.
Montage à l'opposé du bloc moteur.
Demandez le délai de réapprovisionnement et le tarif en cliquant sur le bouton « Ask for a quote ».
Un conseiller traitera votre demande dans la journée.
V6 and V8 engine distribution back on GM basis.
Flat delco head for Mallory brand lighter.
Delco head for Mallory brand igniter.
Internal diameter: 85mm (support groove)
Delco head for Prestolite brand lighter with 2 screw attachment after 1987.
Valves spring with internal reinforcement for GM base engine of types V6 and V8 not Vortec.
- External diameter: 31.04mm
- Internal diameter: 22.05mm
- Height: 51.56mm
Port exhaust collector for Crusader V8 small block engine.
Starboard exhaust collector for Crusader V8 small block engine.
Exhaust valve of the following dimensions:
- Head diameter: 38.10mm
- Thick Diameter: 8.66mm
- Length: 125.23mm
Holley 4 body carburettor flame.
Characteristics :
- External diameter: 180mm
- Diameter housing : 130mm
- Height: 58mm
- 1 sniffling
Flexible fuel length 79cm with 2 connections set in diameter 3/8 on both sides.
Fuel hose allowing a clean and professional installation between the mechanical gas pump and the carburettor.
Planned assembly for carburetors Rochester , Mercab , Edelbrock , Carter - Weber.
For mounting on a Holley brand carburettor you refer to RF201012.
Consider also ordering the BRA200-3814 gear connector for installation on your mechanical petrol pump.
Flexible supply pipe kit allowing the connection of the mechanical fuel pump to the Holley brand carburetor.
For use on Holley or Edelbrock carburetors, use the 704/06 connection in addition.
Fly crown motor diameter 35.6 cm with 168 teeth for GM base engine.